Bathroom Remodeling in Roswell, GA

The last days of a bathroom remodel are when small details get judged: a caulk line, a grout joint, a glass door that closes cleanly or drags. On a Roswell bathroom remodel, Precision Remodeling agrees on the punch-list standard at the start of the project, so you and the crew share the same picture of finished before the first tile is pried loose.

What a punch list is, and why it is settled early

A punch list is the short list of items to correct or complete before a job is closed out. When the standard is agreed in advance, the final review becomes a check against known expectations instead of a debate. It also tells the crew which details deserve extra care while the work is underway, not only at the very end.

Tile details anyone can check

• Lippage: neighboring tile edges should sit flush enough that a fingertip does not catch, especially underfoot. Large tiles are more prone to it and often call for leveling clips during setting.
• Grout joints: even width, fully packed, with no pinholes and no haze left on the tile face.
• Changes of plane: inside corners and the joint where wall tile meets the tub or floor get flexible sealant rather than grout, because those joints move.
• Cuts: trimmed edges land in corners or under trim, not as thin slivers in the middle of a wall.

Tile transitions at the doorway and shower curb belong on the same list. The edge piece should be straight, secure and as level with the surfaces on both sides as the materials allow.

Water tests and fixture checks

Waterproofing cannot be inspected once tile covers it, so it is checked first, usually with a flood test on the shower pan: the drain is plugged and the pan holds water for a set period to show it does not leak. At the end, every fixture is run. Faucets deliver hot and cold on the expected sides, drains empty quickly with nothing dripping underneath, and the toilet flushes fully and sits firm on the floor.

Ventilation gets tested too. The fan should draw air strongly at the grille and push it out at the exterior cap, which confirms the exhaust path is connected all the way and not ending in the attic.

Fit and clearance at the vanity, glass and doors

Vanity sizing and fixture spacing are compared with the plan: drawers open fully without hitting the toilet, the entry door clears the vanity, and the shower door swings freely. Glass should close without rubbing, with an even gap along the hinge side and seals sitting straight. Lighting is checked for even coverage across the mirror, and every switch is tried.

Choosing finishes with the last day in mind

The vanity and top, plumbing fixtures and shower glass configuration are selected before work starts, and samples help. Look past appearance to upkeep: polished chrome shows water spots while matte finishes hide them, and a honed stone top needs periodic sealing while quartz generally does not. Finishes that suit the way you clean keep the room looking the way it did when the crew left.

Underneath, demolition shows the state of the subfloor, the studs and the pipes, and any repair is priced in writing before it is done. For tile choices, see our page on tile installation in Roswell.

Permits from the Roswell Building Division

Roswell is in Fulton County. The city’s permit FAQ says the Building Division issues permits for installing, altering, repairing or replacing plumbing. An owner can obtain one only as a contractor holding a license or as the occupant of the home being altered. Routine upkeep such as painting needs no permit; our page on interior painting in Roswell covers that kind of refresh.

Questions about the finish standard

What belongs on a bathroom remodel punch list?

Typical items are tile lippage, grout gaps or haze, missing sealant at corners and around the tub, uneven transitions, glass doors that rub or drip, drawers that hit a fixture, lights or outlets that do not work, and paint touch-ups where trim meets the wall. Each item is noted, corrected and checked again before the job is closed.

How is a new shower tested for leaks before tile goes on?

The usual method is a flood test. The drain is plugged and the shower pan, with its membrane in place, is filled with water and left for a set period, commonly a full day. The water level is checked at the end; a drop, or any dampness below, points to a leak that is fixed before tiling begins.

Can a Roswell homeowner get a plumbing permit for their own bathroom?

According to the city’s permit FAQ, an owner qualifies for a plumbing permit only as a contractor holding a license or as the occupant of the home being altered. An owner who lives in the house may apply; an owner who does not live there would need a contractor’s license. Ask the Building Division if your situation is unusual.

Set the standard together

To discuss a bathroom in your Roswell home, call 404-409-4448. Describe the room and what you would like changed, and we can arrange a visit, go over the finish standard with you and prepare a written estimate.