Bathroom Remodeling in Smyrna, GA

Most bathroom plans begin with tile and fixtures, yet the wiring behind the walls decides how comfortable the room is to use every morning. Planning a bathroom remodel in Smyrna with Precision Remodeling means talking through outlets, lights, the fan and any heated features early, because each of them has to be roughed in while the walls are open.

Outlets where you actually need them

Start with what gets plugged in: a hair dryer, an electric toothbrush, a shaver, perhaps a lighted mirror or a powered toilet seat. Outlets near water need ground-fault (GFCI) protection, and placing them beside the vanity rather than behind the faucet keeps cords out of the sink. Some vanities and medicine cabinets offer an outlet inside a drawer or cabinet, which keeps chargers off the counter but needs wiring planned before the cabinet is installed.

Layers of light and where the switches go

Vanity lighting works best at face height on both sides of the mirror, or as a broad fixture above it. A ceiling fixture covers the room, and a recessed light rated for wet locations can brighten the shower. A dimmer or a low night light helps on early mornings when full brightness is unwelcome.

Switches usually belong just inside the door on the latch side, so you can reach them before stepping into a dark room. Door swing and fixture clearance are drawn on the plan before boxes are set, so no switch ends up hidden behind the open door.

Fan controls and the exhaust path

A fan on a timer or humidity sensor keeps running after the shower ends, which is when most moisture needs clearing. The exhaust path should be short and lead outdoors, never into the attic. Both the control and the duct route are decided before the ceiling is patched, since changing either afterward means cutting into finished drywall.

Heated floors and towel warmers

Electric radiant mats sit under the tile, embedded in thinset or a self-leveling layer, and need power and a wall thermostat; larger mats often need their own circuit. They pair well with tile, which holds and spreads heat. A hardwired towel warmer needs an electrical box at the right height behind it. Both are far simpler to add during a remodel than later.

A heated floor also affects tile transitions. The mat and its leveling layer raise the floor slightly, so the threshold at the door is sized after the floor buildup is known. The subfloor condition is checked first, since soft spots can crack tile and strain the heating cable.

The wet area: shower layout, waterproofing and storage

The electrical plan has to agree with the shower layout. Switches and ordinary fixtures stay out of the spray zone, and the valve and showerhead positions are fixed before any wiring runs nearby. Waterproofing covers the shower walls, floor and any niche, and storage such as a recessed niche or medicine cabinet goes into stud bays free of wires and pipes. Drain and supply locations are confirmed at the same time.

The glass, tile, grout and hardware are settled before ordering. Glass hinges and towel bars need blocking, which goes in while the walls are open, right alongside the new wiring. More about tile is on our tile installation in Smyrna page, and the Smyrna remodeling services page lists other projects we take on.

Smyrna permits and inspections

Smyrna is in Cobb County. The city’s Community Development Department accepts permit applications only through its online portal, and inspection requests received by 4 p.m. are scheduled for the following business day. A homeowner may pull a permit only for a home that is their current permanent residence and is listed in their legal name. A landlord cannot do the work on a rental unit unless they hold a Georgia contractor’s license.

Electrical and permit questions

Can a heated floor be added during a bathroom remodel?

Yes, and a remodel is the easiest time to add one. An electric mat is laid over the prepared subfloor and embedded in thinset or a leveling layer before the tile goes down. It needs power, sometimes a dedicated circuit depending on its size, plus a wall thermostat. The extra floor height is accounted for at the doorway transition.

How many outlets should a bathroom vanity have?

There is no single right number, but most people want at least one outlet within easy reach of each sink, placed to the side so cords do not drape across the basin. A double vanity often gets one at each end. Outlets near water need GFCI protection, and an in-drawer outlet is an option if you want chargers off the counter.

Can a Smyrna landlord remodel a rental bathroom under their own permit?

Generally not. The city allows a homeowner permit only for the owner’s current permanent residence held in their legal name, so a rental does not qualify. A landlord can do the work personally only with a Georgia contractor’s license; otherwise a contractor takes on the job and applies through the city’s online portal.

Plan the wiring with us

If you are planning a bathroom remodel in Smyrna, call 404-409-4448. Tell us what you would like to plug in, light and heat, and we can arrange a visit to look at the room and prepare a written estimate.