Carpet Installation in Atlanta, GA

Choosing carpet is mostly about what you see and feel, but carpet installation in Atlanta homes also depends on measurements most people never think about: the gap under each door, the height where carpet meets a hard floor, the width of a room compared with the width of the roll. Getting those right is what keeps new carpet flat, quiet and good-looking.

We start with the subfloor and the doors, help you settle color and style, and then lay out seams and pile direction before anything is ordered. Planning more than new floors? Start with our page on remodeling services in Atlanta.

Starting with the floor under the old carpet

Old carpet hides a lot. Once it is up, we check the subfloor for movement, stains, odors and damage, and look at whether the existing tack strip is still tight and correctly spaced from the wall. Panels that flex are screwed down, soaked or crumbling sections are replaced, and pet stains that have reached the wood can be sealed with an odor-blocking primer before the new pad goes in.

A flat, firm base matters more for carpet than people expect. Ridges, humps and raised fasteners eventually show as worn lines on the surface.

Doors, thresholds and transition height

On our visit we swing every door that opens over the carpeted area and note how much clearance it has. New carpet over a fresh cushion is often taller than a worn carpet that has packed down, so a door that moves freely today can drag afterward. Doors that need it are trimmed and rehung.

We also measure where carpet will stop against tile, wood or vinyl. The height difference between the two floors decides which transition hardware makes sense, from a tucked edge held by a hidden gripper to a reducer strip that ramps down to a lower surface.

Choosing a color that suits the room and the household

Color decisions go wrong most often when samples are judged under store lighting. Bring them home and look at them on the floor, near the windows and under your lamps at night. Very light colors show soil and traffic lanes; very dark solids show lint, dust and pale pet hair. Mid-tones and flecked or heathered yarns hide everyday dirt well.

Fiber and pile style change how a color reads. A cut pile shows shading as the yarn leans in different directions, while a loop or textured style looks more even. Once you decide, all the carpet for connected rooms should come from one production run, or dye lot, so the color matches from room to room.

Seams, room dimensions and pile direction

We measure every room and draw where seams will fall and which way the pile will run. Seams are kept out of doorways and main walking lines where possible, and every piece in view of another is laid with the pile pointing the same way. A piece that is turned reflects light differently and looks like another shade, even though it came off the same roll.

The finished layout tells you how many square yards are needed and why that figure is higher than the floor area.

From cushion to stretched carpet

With the floor ready, tack strip is installed or repaired around the perimeter, leaving a small gap at the wall for the carpet edge to tuck into. Pad is laid inside the strip with its own seams taped. Carpet pieces are positioned, joined with heat-activated seam tape and then power-stretched across the room so the backing sits tight on the pins. A power stretcher, rather than a knee kicker alone, is what keeps ripples from forming later.

Stairs and closets are finished last, and furniture goes back carefully so legs do not snag the new pile. A last walk-through looks for any edge that has pulled away from the wall or any seam that needs attention.

Permits and related work in Atlanta

Atlanta lies in Fulton and DeKalb counties. If your carpet project uncovers damaged framing, or you plan to move floor outlets or plumbing while the floor is open, the City of Atlanta Department of City Planning’s Office of Buildings is where to ask if that part of the work calls for a permit.

Common questions on color, dye lots and doors

Which carpet colors hide everyday dirt?

Mid-tone colors and yarns with flecks or a heathered mix of shades usually hide soil, lint and small stains far better than very light or very dark solids. Light carpets show traffic lanes, and dark ones show dust and pale pet hair. Look at samples at home in daylight and again at night before deciding, since lighting changes how a color reads.

Why should all my carpet come from one dye lot?

Carpet is dyed in production batches, and two batches of the same style and color name can differ slightly. In separate rooms that might go unnoticed, but where two pieces meet at a seam or doorway, a mismatch is easy to see. Ordering the full quantity at once, from a single lot, keeps the color consistent across connected rooms.

Can new carpet keep my doors from closing?

It can, if the new carpet and pad are taller than the old floor and a door has little clearance. We test each door during the visit and note any that are likely to rub. Those doors are removed, trimmed along the bottom edge and rehung so they swing freely. Ask whether that trimming is included in the estimate.

Schedule an Atlanta carpet estimate

Call 404-409-4448 and describe the rooms, the flooring there now and the look you have in mind. Someone from our team can then come out, take measurements and prepare a written estimate.