Exterior Painting in Lithia Springs, GA
Walk around almost any house and the paint near the ground looks older than the paint higher up. Exterior painting in Lithia Springs gives you a chance to deal with that lower band properly: the bottom courses of siding, the trim that meets the foundation, and the metal pieces that live close to wet soil and mulch.
That zone is where rain, sprinklers and dirt do the most damage, and where a repaint most often fails early.
Why the bottom boards give out first
Rain that hits a patio, a driveway or bare soil bounces back onto the wall, carrying grit with it. The bottom foot or two of siding stays damp longer after every storm, and shaded corners may hardly dry at all between rains. Over time the paint there blisters, peels and lets water reach the wood or the cut edges of fiber cement.
During a site visit we look closely at that band on every side of the house, pressing on the bottom boards, corner boards and door trim to find soft spots, and checking the joints where siding butts into trim for gaps that have opened.
Splashback, sprinklers and soil contact
Paint alone cannot fix a wall that stays wet. A few things are worth noticing before any coating goes on:
- Mulch or soil piled against the siding, which keeps the bottom edge soaked.
- Irrigation heads that spray the wall instead of the bed.
- Downspouts that empty right beside the foundation.
- Roof runoff that pours from a valley or a gutter seam onto the same spot.
We point these out in the estimate so you can decide whether to adjust the beds, re-aim sprinklers or extend a downspout. Changes like these often do more to protect new paint than any product upgrade.
Rust on metal near the ground
Metal at the base of the house corrodes faster than metal up high. Steel crawlspace vents, the bottoms of downspouts, basement doors, hose bib flanges and railing posts set in concrete all tend to show rust first. Loose rust and scale are removed down to firm metal, the bare spots get a rust-inhibiting primer, and the finish coat follows.
Metal that has rusted through or lost its strength is not painted over. It is listed for repair or replacement, since paint on a perforated vent or a crumbling railing base only hides the problem for a short while.
A base band, skirt or foundation color
Some homes have a water table board, a painted foundation or a parged block skirt along the bottom of the walls. These are good candidates for a slightly darker accent than the body, which hides splashed dirt between cleanings. Painted masonry foundations need a coating that lets moisture escape, so a masonry primer and a breathable exterior acrylic are typical choices there.
Sheen is part of the same decision. A satin finish on the lower band wipes clean more easily than flat paint, while trim with open joints or patched areas may look better in satin than in semi-gloss.
Coatings and caulk for a wet zone
Compatibility matters even more where moisture is constant. Bare or repaired wood near the ground is primed on all sides that can be reached, and end grain at the bottoms of corner boards and door casings is sealed before the finish coats. If the existing paint is oil-based, a bonding primer is used under the new acrylic.
Caulk goes into vertical gaps between siding and trim, around penetrations and at the seams of corner boards. The horizontal overlap under each lap board is left open so trapped water can drain, and the gap between the bottom course and a concrete surface is not sealed shut either.
Douglas County permit contacts
Lithia Springs is in Douglas County. If the work expands beyond painting into structural repairs, plumbing or electrical changes, ask Douglas County Development Services, Building Permits and Inspections whether a permit applies. Bigger plans for the house are covered on our Lithia Springs remodeling services page.
Questions about the lower walls and foundation
Why is the paint peeling only along the bottom of my siding?
The bottom boards take the most water. Rain splashes up from hard surfaces, sprinklers may hit the wall, and soil or mulch can keep the bottom edge damp. Moisture behind the paint pushes it off the surface. Repainting helps only if the wet wood is repaired and dried, the bare edges are primed, and the source of the water is reduced.
Can a painted block foundation be repainted the same way as siding?
It needs a different system. Block and parged foundations hold moisture from the ground, so they are cleaned, loose coating is removed, and a masonry primer and breathable exterior coating go on. Paint meant for wood can trap that moisture and peel. White powder on the surface is a sign water is moving through the masonry and should be addressed before painting.
Should rusty crawlspace vents be painted or replaced?
If the metal is still solid, cleaning off the rust, priming with a rust-inhibiting primer and painting is reasonable. If the louvers or frame have rusted through, replacement makes more sense, since a vent with holes lets pests in and will not hold paint for long. The estimate should say which vents are being painted and which are recommended for replacement.
Start with a walk around the base of the house
Give us a call at 404-409-4448 and tell us where you see peeling, rust or soft trim. We can look at the whole exterior, starting from the ground up, and write an estimate that separates painting, repairs and the drainage items you may want to handle yourself.