Bathroom Remodeling in Holly Springs, GA

It is easier to plan a bathroom when you think of it as a few zones rather than one room. The vanity area, the shower or tub, the ceiling with its fan and lights, and the floor each have their own problems to solve. Precision Remodeling uses that approach for bathroom remodeling in Holly Springs, starting with lighting, storage and waterproofing, the three areas homeowners most often want improved.

The vanity zone: lighting, storage and hardware

At the vanity, lighting does the heavy lifting. Fixtures mounted at either side of the mirror throw even light across the face, which is why they are preferred for shaving and makeup. If the mirror spans most of the wall, a fixture above it works, ideally paired with ceiling lights.

Storage at the vanity can include deep drawers, a pull-out organizer, a recessed medicine cabinet or a tall cabinet alongside the sink. Hardware and accessories, such as towel bars, hooks and the paper holder, are chosen at the same time so backing goes into the walls where each one will mount. A single finish across faucets and hardware keeps the zone looking deliberate.

The wet zone: waterproofing and shower layout

Inside the shower, the priority is keeping water out of the walls. That means a continuous waterproof membrane behind the tile, sealed at seams, inside corners, the curb and every pipe opening, with a floor that slopes steadily to the drain. A flood test of the shower base before tile confirms it holds.

The shower layout is drawn at the same stage: where the valve sits, how high the showerhead goes, whether there is a bench or niche, and how the glass opens without hitting the toilet or vanity.

The ceiling: fan and exhaust path

A bathroom fan has to move humid air outside. We follow the exhaust path from the fan housing to the end of the duct, checking for a duct that stops in the attic, a crushed run or too many bends. Fixing the route and choosing a fan sized for the room prevents mildew on the ceiling and peeling paint above the shower.

The floor and the framing

The subfloor is checked for soft spots and flex, since tile cracks over a floor that moves. Floor transitions at the doorway are measured, because new underlayment and tile can raise the floor above the hallway. With the walls open, any decayed plates or crooked studs near the wet areas are corrected, and the pipe stub-outs are moved to suit the new fixtures.

If tile is a big part of your plans, our page on tile installation in Holly Springs covers layouts and preparation in more detail.

Plumbing permits in Holly Springs

Holly Springs is in Cherokee County. The city’s code requires an owner, agent or contractor to get a permit from the city’s building official before installing, altering, repairing or replacing a plumbing system covered by the construction codes, according to Section 18-91. The Community Development Department handles building permits, electronic plan submittals and code enforcement for the city.

Phasing and the order of work

If the budget calls for doing the bathroom in stages, the hidden work should go first: pipes, the shower membrane, ductwork for the fan and any subfloor fixes. Visible items like the mirror, light fixtures or accessories can be updated later. It also pays to buy extra tile for the later stage now, since a matching dye lot can be hard to find a year on.

For a single project, the sequence runs from protection and removal to rough changes, then waterproofing with fixture spacing confirmed, then tile, fixtures, glass and trim. Before the final review, the floor edge at the doorway and the vanity position are checked, and the door is swung to make sure it clears the vanity and toilet.

Frequently asked questions

Does Holly Springs require a permit for bathroom plumbing changes?

Section 18-91 of the city code requires an owner, agent or contractor to get a permit from the building official before installing, altering, repairing or replacing a plumbing system covered by the construction codes. The Community Development Department handles building permits and electronic plan submittals, so it can confirm what a particular bathroom project needs.

Where should towel bars and grab bars be planned?

Plan them before the walls are closed. A towel bar works best within reach of the shower exit, a hook near the door suits robes, and grab bars belong where someone steps in or sits down. Each needs solid wood backing behind the drywall or tile, which is added during framing so the hardware is anchored securely.

Is there an inspection if a drain is moved under a slab?

Holly Springs’ code (Section 18-98) calls for an underground plumbing inspection after trenches are dug and the piping is installed, but before any backfill. Moving a shower or toilet drain in a slab house means cutting a trench in the concrete, so plan for that trench to stay open until the inspection, and ask Community Development how the rule applies to your project.

Go zone by zone with us

Call 404-409-4448 to describe your bathroom and the zone that bothers you most, whether it is the vanity, the shower, the ceiling or the floor. We can schedule a visit, take measurements and prepare a written estimate.