Bathroom Remodeling in College Park, GA

The vanity wall is where a bathroom gets judged every day: it is where you brush your teeth, shave, do makeup and check your reflection on the way out. In bathroom remodeling projects around College Park, Precision Remodeling often starts there, sizing the cabinet and planning the lighting before moving on to the shower and floor.

The sections below explain what we check, which decisions come first and how the estimate lays out the work.

Getting the vanity size and lighting right

A vanity that is too large for the room makes the bathroom feel cramped and can block the door or crowd the toilet. One that is too small wastes wall space that could hold storage. We measure the wall, the swing of the entry door and the clearance beside the toilet, then suggest widths that fit with room to spare.

Lighting comes next. Placing fixtures at face height on both sides of the mirror gives the most even light, while a fixture above works when the mirror is wide. A ceiling light or recessed cans fill in the rest of the room, and a wet-rated fixture can brighten the shower. Outlets are marked on the same plan, so a hair dryer or toothbrush charger does not end up with a cord draped across the sink.

Drains, supplies and what is under the floor

Before committing to a new layout, we locate the existing drain and supply lines. Whether the bathroom sits over a crawlspace, a basement or a slab changes how easily a drain can move. Supply lines are checked for age and material, and shutoff valves are tested, because a valve that will not close becomes a problem the moment work starts.

The floor is checked for flatness and stiffness. Floor transitions and subfloor condition go together: if the subfloor needs another layer or repairs, the finished floor rises, and the threshold to the next room has to account for it.

Tile, grout and the threshold

Tile and grout are chosen for both looks and upkeep. Small mosaic tiles suit shower floors because the many grout joints give traction and let the tile follow the slope to the drain. Large porcelain tiles make a floor look calmer but demand a very flat base. Grout color matters more than people expect; a mid-tone hides everyday dirt better than bright white.

At the doorway, the transition from bathroom tile to the hallway floor is usually handled with a marble or quartz saddle or a low metal profile. For deeper detail on tile layouts, see our tile installation services in College Park.

Picking a shower glass configuration

Shower glass options range from a single fixed panel to hinged doors and sliding enclosures. A hinged door needs clear floor space to swing out and solid backing at the hinge wall. Sliding doors suit narrow rooms but have a track to clean. A fixed panel keeps things simple and works well when the shower is long enough that spray stays inside. The glass is measured after tile is complete, since it must fit the finished surfaces exactly.

Plumbing permits and inspections in College Park

College Park spans parts of Fulton and Clayton counties. Plumbing permits come from the city’s Department of Building and Inspections, which runs plan review, permits and inspections online in SagesGov. Under the city code, installing, altering or repairing plumbing is unlawful until a written application has gone to the building official and a formal permit has been issued (Sec. 5-122). Inspections are made by the building official or authorized representatives, and the city does not let master plumbers or utility contractors self-inspect water and sewer projects (Sec. 5-127).

Reading the estimate

Line by line, a good estimate shows the old finishes being torn out, the parts of the room being kept, the new materials and the way each one will be installed. It should also cover protection of the house, cleanup and anything excluded, so two bids can be compared on equal terms.

On site, the house is protected and the old room comes out first. Rough plumbing and electrical follow, then framing for niches and cabinets, waterproofing and tile, and finally the vanity, fixtures, glass and trim. Before we call the job done, the fan is run to confirm it vents outside and every grout and caulk joint is looked over.

Frequently asked questions

What lighting works best over a bathroom vanity?

Lights mounted on both sides of the mirror at roughly face height give the most even light, because they illuminate the face from the front without casting shadows. If the mirror is too wide for side fixtures, a bar light above it is the usual alternative. Adding a ceiling light helps fill the room, and a dimmer is useful for nighttime trips.

Does College Park allow plumbers to self-inspect their work?

Not for water and sewer projects. Section 5-127 of the College Park code says inspections are made by the building official or authorized representatives, and the city does not let master plumbers or utility contractors self-inspect those projects under O.C.G.A. § 8-2-26(d). The city’s Department of Building and Inspections schedules inspections through its online SagesGov system.

Are mosaic tiles a good choice for a shower floor?

Yes, for most showers. The small size lets the tile follow the slope toward the drain without lippage, and the many grout joints add slip resistance underfoot. Larger tiles can work on a shower floor with a linear drain, since that floor slopes in one direction only. Either way, the waterproofing underneath matters more than the tile size.

Begin at the vanity wall

Call 404-409-4448 to describe the bathroom you want to update, starting with what works and what does not at the sink. We can visit, measure the room and walk through the conditions with you, then prepare a written estimate based on your project.